Loading...

UTV PR-100 Production PRP01 - PRP99

Limited UTV 2000 CC Normally Aspirated

2024 Class Consolidation Retired

2024 Class Consolidation

utv-pr-100-pruduction-off-road-vehicle

Limited UTV 2000 CC Normally Aspirated

Last Updated May 15, 2024

DEFINITION

Two seat vehicles built using a production UTV. Any manufacture UTV may be used providing the model used has been series produced in a minimum of 1000 units within a twelve (12) month period. Maximum engine size 2000cc. Stock production body parts required.

GENERAL REGULATIONS

Entrants in this class shall comply with all applicable general regulations.

TECHNICAL REGULATIONS

This class is a Stock Production class, and all components will be considered Stock Production unless unrestricted herein. If it does not say it can be removed, replaced, or modified it has to remain stock as delivered by the manufacturer of the vehicle.

Manufactures body, engine, transmission, chassis, suspension, and drive train components must be retained.

NOTE: The UTR abbreviations listed under this class (I.E. UTR1 HELMETS) refer to UTR cross reference listings in the front of this book. These UTR cross-referenced listings are part of the class rules. Where a conflict occurs between the UTR cross-referenced listing and a rule contained under this class, the rule contained under this class takes priority.

SAFETY EQUIPMENT

UTR1 HELMETS

UTR2 PROTECTIVE CLOTHING

UTR3 EYE PROTECTION and DENTURES

UTR4 HEAD AND NECK RESTRAINTS

UTR5 FIRST AID KIT

UTR6 EMERGENCY SIGNALING DEVICES

UTR7 HORNS

UTR8 REFLECTORS

UTR9 FIRE SUPPRESSION EQUIPMENT

UTR10 SURVIVAL SUPPLIES

SUSPENSION COMPONENTS

UTR11 SHOCK ABSORBERS and BUMP STOPS

Any shock in stock location is allowed.

Springs may be of any size and manufacture.

UTR12 SECONDARY SUSPENSION

No secondary suspension allowed.

UTR13 WHEELS and TIRES

Wheel diameter is fifteen (15) inch maximum.

Maximum tire size is 35x12.5x15.

UTR14 FASTENERS

STEERING and BRAKE COMPONENTS

UTR15 STEERING

UTR16 BRAKES

ELECTRICAL SYSTEM

UTR17 IGNITION

UTR18 BATTERIES

All batteries must be securely mounted. Battery shut off switch is required.

UTR19 LIGHTS

All vehicles must have a minimum of two (2) taillights and two (2) brake lights. Tail and brake lights must be 3 inch in diameter. All UTV's must also have four (4) additional rear facing safety lights. One (1) solid amber, one (1) flashing amber, one (1) solid blue, and one (1) flashing blue. All safety lights must be LED with a minimum of 2000 lumens output. All safety lights must be wired directly to the battery switch. All lights must be mounted 48 inches from the ground minimum. Safety lights must be on at all times. Vehicles without working safety lights will not be allowed to leave the starting line or pass through a check point. All lights subject to Unlimited Off-Road Racing approval.

UTR20 STARTERS

FUEL SYSTEM

UTR21 FUEL

UTR22 FUEL TANKS

UTR23 FUEL FILLERS LINES, VENTS, and CAPS

Stock tank in stock location or Fuel cell in any location.

ENGINE, TRANSMISSION and DRIVELINES

UTR24 ENGINE and ENGINE DISPLACEMENT

Maximum engine displacement is 2000cc.

Engine must remain stock as delivered by the manufacture.

No engine parts may be modified or replaced.

Clutch housing cooling inlet and outlet tubes (snorkels) maybe modified or replaced.

Any manufacturer air cleaner in stock housing is allowed.

UTR25 ENGINE REPLACEMENT

UTR26 TRANSMISSION

UTR27 THROTTLES

UTR28 EXHAUST

UTR29 DRIVE SHAFTS

UTR30 FLYWHEEL SHIELDS

UTR31 FLUID COOLERS

UTR32 AUXILIARY EQUIPMENT

UTR33 SUPERCHARGERS and TURBOCHARGERS

VEHICLE SAFETY EQUIPMENT

UTR34 ROLL CAGES

Stock production roll cages are not allowed.

UTR35 SAFETY HARNESS

UTR36 SAFETY NETS

UTR37 SEATING

Race seats only. All stock seats must be removed.

GENERAL VEHICLE COMPONENTS

UTR38 DRIVERS COMPARTMENT

UTR39 DOORS AND LATCHES

Doors must be securely closed.

UTR40 FIREWALLS

UTR41 BALLAST

UTR42 WEIGHT

UTR43 FLOORBOARDS

UTR44 BUMPERS and HAZARDOUS PROTRUSIONS

Safe front and rear bumpers required. No shape corners or hazardous protrusions.

UTR45 MIRRORS

UTR46 SKID PLATES

UTR47 STORAGE

UTR48 CHASSIS and BODY

Stock grill, hood, and front and rear fenders must be used.

Roof must be covered with sheet metal .060 thick minimum.

UTR49 HOSES

UTR50 IDENTIFICATION MARKINGS

Unlimited Off-Road Racing will assign race numbers.

UTR51 ADVERTISING on VEHICLES

UTR52 RADIO EQUIPMENT

UTR53 WORKMANSHIP

UTR54 TRACKING DEVICE

Available Vehicle Numbers

PRP01 PRP02 PRP03 PRP04 PRP05 PRP06 PRP07 PRP08 PRP09 PRP10 PRP11 PRP12 PRP13 PRP14 PRP15 PRP16 PRP17 PRP18 PRP19 PRP20 PRP21 PRP22 PRP23 PRP24 PRP25 PRP26 PRP27 PRP28 PRP29 PRP30 PRP31 PRP32 PRP33 PRP34 PRP35 PRP36 PRP37 PRP38 PRP39 PRP40 PRP41 PRP42 PRP43 PRP44 PRP45 PRP46 PRP47 PRP48 PRP49 PRP50 PRP51 PRP52 PRP53 PRP54 PRP55 PRP56 PRP57 PRP58 PRP59 PRP60 PRP61 PRP62 PRP63 PRP64 PRP65 PRP66 PRP67 PRP68 PRP69 PRP70 PRP71 PRP72 PRP73 PRP74 PRP75 PRP76 PRP77 PRP78 PRP79 PRP80 PRP81 PRP82 PRP83 PRP84 PRP85 PRP86 PRP87 PRP88 PRP89 PRP90 PRP91 PRP92 PRP93 PRP94 PRP95 PRP96 PRP97 PRP98 PRP99

UTV PR-100 Production Drivers

Looking for More?

Check out the UNLTD Drivers page to see more drivers or the UNLTD Classes page to see the specs, rules, and drivers for another vehicle class.

Drivers Classes
Top